Super payso2
New member
I just order a new power supply for my pm10w and they where working good until they started to blinking red and green light any one can help me..
Mp10w blinking red and green light?
- Thread starter Super payso2
- Start date
#theMatrix
Active member
http://ecotechmarine.com/faq/troubl...hat-do-the-different-led-error-codes-indicate
Red and green is a stall. When i got red and green my wetside magnet warped and cracked causing it to stop
Red and green is a stall. When i got red and green my wetside magnet warped and cracked causing it to stop
Super payso2
New member
I check the magnet and it looks good.. I'll check again thanks if I can't fix it I'll toss it
jrpark22000
Premium member
I've had corroded wires inside the motor casing cause red/green lights. Wasn't a fix for it other than a new dryside.
Super payso2
New member
Thanks for the info mostly that's the problem oh well I'll have to buy a new set side
#theMatrix
Active member
Well. Do you have access to another mp10? That way you can rule out? Josh said his was the dry side and i said it was the wet side
If your wet side magenet looks warped and theres some grinding on the flat cap then id say its stalling.
Im not sure about the dry side motor giving issues.
Super payso2
New member
Wet side looks good magnet is not crack. But I can't tell in the dry side is bad since i don't even know how to open it...
#theMatrix
Active member
Try doing a reset. I think its called a dry side calibrating reset or something like that. Basically letting the dry side cablibrate with out the wet side being attached
jrpark22000
Premium member
It's not too hard to open, but you def void any shape of warranty. You have to pull the round sticker off the back to get to the screws, then seperate the large round front plastic piece.
Super payso2
New member
I'll try to do that today hope It works..
Super payso2
New member
I manage to open the dry side and it looks like motor is all mess up. Thanks again for the help guys..