superchargedgp
Well-known member
I have 2 mp10s hooked up to wxm module
This is the settings i have them on. My question is do change the power to 100 percent on the slave? Or leave it as is. Will leaving it at say 40 percent run the slave pump at 40 percent of full power, or 40 percent of maximum power set on the master pump?
This is the settings i have them on. My question is do change the power to 100 percent on the slave? Or leave it as is. Will leaving it at say 40 percent run the slave pump at 40 percent of full power, or 40 percent of maximum power set on the master pump?
