Neptune Apex - Adding additional Temp Probe

IHaveCrabs

IHaveCrabs

Premium member
So for redundancy or for an additional tank, if adding a second temp probe do you need to purchase another PM1 module or is there another/cheaper way to do so?

Since I have two displays running off the same pump/sump, I'd like to run separate temp probes to know the actual readings per tank.
 
I was reading up and for apex. Seems most go the aquacontroller route for the 2nd aquarium set up.

Not what you wanted to hear but...yea
 
The pm modules are the only way to add additional temp proves, I believe the pm2 offers the capability as well and then you can add conductivity monitoring


Sent from my iPhone using Tapatalk
 
I looked at the PM2 specifically for using conductivity probe in my kalk reactor, to indicate when it needs 'reloaded'.

Haven't been able to justify the cost over just reloading kalk on a schedule...can't overload, it just stays out of solution for a while


Sent from my iPhone using Tapatalk
 
You must log in or register to reply here.
Back
Top