Prov3:5-6 Slow and steady build

Prov3:5-6

Active member
Back at it again after years away. Couldn’t resist the itch. I picked up a DB 80 and worked with my bro in law to build a custom stand. All plumbing will be sent through the wall and into the basement. I’m having an issue with figuring out what size bulkheads and what size pipe I need. Based on the pictures below, does anyone know what sizes I’m going to need?? View attachment 22884 View attachment 22885

- - - Updated - - -

View attachment 22886
 

#theMatrix

Active member
To make your plumbing even I would say a 1 1/4 bulkhead to fit in the 1in PVC. The "gap" would be sealed by the bulkhead edge and gasket. I would go with a slip x slip so the PVC slides in from both sides and the bulkhead gets thread locked into the glass.
 
Top