Brand NEW MP10 dryside??? Too few wires and flashes red/green

jrpark22000

jrpark22000

Premium member
Anyone replace an old mp10 dryside with a new one recently? The brand new dryside has half as many wires going to the controller as compared to the old dryside. When I plug in the new dryside the controller flashes green/red. Anyone have to deal with this before?

The drive manuf date is 2011.
 
I have 3 mp10, I was able to swap drivers, motors, and power supplies. It's how I knew my old dryside was fried. The new dryside has the same problem on both of the drivers I tested.
 
That's why I'm asking. There isn't a part number for anything other than the current MP10s. Before ordering it looked like all parts were compatable.

I'm hoping this isn't the first time it's been done and someone had luck getting it to work, firmware upgrade, tip, trick, worked with ecotech, etc.
 
jrpark22000 said:
That's why I'm asking. There isn't a part number for anything other than the current MP10s. Before ordering it looked like all parts were compatable.

I'm hoping this isn't the first time it's been done and someone had luck getting it to work, firmware upgrade, tip, trick, worked with ecotech, etc.
Click to expand...
For another 50$ u can get the driver lol. It weird cause u can upgrade the drivers to quiet drive so id guess u can upgrade the dry side too i just got mp40s so im a mp nube
 
madjoe said:
For another 50$ u can get the driver lol. It weird cause u can upgrade the drivers to quiet drive so id guess u can upgrade the dry side too i just got mp40s so im a mp nube
Click to expand...

When you compare the mp10es to the qd, the upgraded driver gets you nothing. There are reports it may be quiter, but that is it at best. My ES driver is without fault, there's no reason to have to spend the extra $50 except for the fact ecotech is again forcing consumers to upgrade. They're stopping production of all parts for non QD models. MP40 wetsdie rebuilds were the first to go, now drysides too.

IMO its an underhanded method to get people to spend more money. Make people buy new vs being able to support otherwise good working products.
 
jrpark22000 said:
When you compare the mp10es to the qd, the upgraded driver gets you nothing. There are reports it may be quiter, but that is it at best. My ES driver is without fault, there's no reason to have to spend the extra $50 except for the fact ecotech is again forcing consumers to upgrade. They're stopping production of all parts for non QD models. MP40 wetsdie rebuilds were the first to go, now drysides too.

IMO its an underhanded method to get people to spend more money. Make people buy new vs being able to support otherwise good working products.
Click to expand...
I have one of each the qd is pretty silent but the other isnt bad either . I would think though if u could switch drivers then u should be able ro switch dry sides . Im guessing u didnt find any info on tge interweb
 
jrpark22000 said:
Thanks for looking. I've been digging and still can't find any useful info out on the web, even on the big forums.
Click to expand...

Have u contacted ecotech at all maybe they can tell u i cant find anything on the web site fives a part number of mp201 i believe is regular no qd but like other guy said i havent even found a quiet drive dry side just the driver it self so idk what going on
 
You must log in or register to reply here.
Back
Top